Need help?Do you have a question about the Panasonic FP2 and is the answer not in the manual?
General| Mounting | DIN rail |
|---|---|
| Model | FP2 |
| Type | PLC |
| Output Type | Relay |
| Communication Ports | RS232C, RS485 |
| Programming Language | Ladder Logic |
| Memory | 8KB |
| Operating Temperature | 0°C to 55°C |
| Input Voltage | 100 to 240 VAC or 24 VDC (depending on the module) |
Details critical safety warnings and cautions for product usage.
Defines baud rate and bits per character for serial communication.
Explains start/stop bits for synchronization and parity for error checks.
Details hardware flow control signals CS and CD for data transmission.
Specifies end codes to mark the termination of data frames.
Explains flow control to prevent data loss during communication.
Details the 9-pin RS232C connectors for data communication.
Explains the purpose and direction of each RS232C signal line.
Guides on configuring communication parameters via switches and memory.
How to configure transmission format using physical DIP switches.
Procedure for updating transmission format using shared memory.
Actions to take when unit errors occur, indicated by LEDs.
Steps to resolve problems with sending or receiving data.
Specific solutions for issues indicated by the ALARM LED.
Specific solutions for issues indicated by the ERROR LED.
To Next Page
