Panasonic FV-23BW2H - How to Use Heating Function; Starting Heating Mode; Setting Operating Time; Stopping Heating Midway

取暖功能的使用方法
HOW TO USE HEATING FUNCTION
Used when you feel cold in a bath
In the heating mode running for 30 seconds above, press the
button to stop the heater. The fan will stop running after a delay of
10 seconds.
Heater may stop heating when temperature in bathroom is up to
required degree, and may restart heating as the temperature in
bathroom cools down.
2.
1.
Hot startup function: After the product starts up in the heating mode
when the temperature in the bathroom is lower than 20 °C, it enters the
hot startup status to avoid blowing of cold air, and the fan runs at a low
speed. When the temperature in the bathroom reaches 20 °C or above
or after running for 60 seconds, the hot startup status stops and the fan
runs at a high speed.
1
2
4
5
在浴室中感到冷時使用
在沐浴前開取暖功能，可 提前把浴室加溫。
按 按鈕，取暖模式以強檔 開 始運轉，再按一次切換 為 弱檔。
運轉過程中，可通過 調整 設 置時間。
運轉過程中，可通過 按鈕 ， 調整風向。
當浴室內溫度上升到一 定 程度時，加熱器停止工 作 ，待溫度下降到一定程 度 後，
加熱器重新開始工作。
運轉完所設置時間後，本 機會自動停止。
如需在運轉途中停止，請 按 按鈕。
熱啟動功能：當浴室溫 度 低於20 °C時，以取暖模式啟動 後 ，為避免冷風吹出，
產品進入熱啟動狀態，扇 葉以低速運轉，待浴室 溫 度達至20 °C以上或經過60秒
後，熱啟動狀態停止，扇 葉以高速運轉。
若在取暖模式運轉30秒以上 ， 按 按鈕後，為使加熱器冷 卻 ，扇葉將延遲
10秒停止運轉。
Before taking a bath, start the heating function to warm the bathroom
beforehand.
Press the button to start the heating mode at the HI mode.
During running, you can press to change the set time.
This product will stop automatically when the set time is up.
To stop midway in running,pressthe button.
3
During operation, you can press the button to change the air
direction.
(Initial settings)
(初始 設置)
強
HI
弱
LO
18
It will switch to the LO. mode if you press this button again.