The filter mesh in the filter mesh assembly provides the antibacterial function, with
the antibacterial ratio against staphylococcus aureus and the antibacterial ratio
against colibacillus up to 99.9% respectively (test basis: JIS Z2801:2000)
After use for a period of time, the colour of the filter mesh will change from white
to brown, but the change to material colour will not affect performance.
As the use time increases, the antibacterial performance of the filter mesh will
decrease accordingly.
ANTIBACTERIAL FUNCTION
過濾網組合中的過濾網 具 有抗菌功能，其對金黃 色 葡萄球菌抗菌率達到99.9%，大 腸桿菌抗菌
率達到99.9%。（檢測依據：JIS Z2801：2000） 。
使用一段時間後，過濾 網 的顏色會從白色變成茶 色 ，這種材質顏色的變化 並 不影響性能。
隨著使用時間的增加，過 濾網的抗菌性能會相應 減 弱。
抗菌功能
每次清潔過濾網後，建 議 將過濾網清潔提示的累 計
時間復位。(長按模式按鈕3秒 ， 聽到“嘀”的一聲，
復位完成。)
Press and hold the MODE button at the receiving part of the unit body for 3
seconds. A “beep” means the filter cleaning indication is cleared. (The
accumulated time of the filter cleaning indication will be reset, and the time
will be accumulated again.)
開啟“電源全極開關” 。
取消機體接收部過濾網 清 潔提示。
Turn on the all-pole switch.
Clear the filter cleaning indication at the receiving part of the main body.
Each time cleaning the filter , you are advised
to reset the accumulated time of the filter
cleaning indication. (Press and hold the MODE
button for 3 seconds. A “beep” means the
resetting is done.)
長按機體接收部模式按 鈕3秒 ，聽到“嘀”的一聲，過 濾網清潔提示將被解除 。
(過濾網清潔指示的累計 時 間將復位，重新累計。)
重新安裝過濾網組合。
Reinstall the filter assembly.
將過濾網組合從面板組 合 的斜上方取出。
用吸塵器清除過濾網上 的 灰塵和污垢。
Remove the filter assembly from the slant
upward side of louver assembly.
Use a vacuum cleaner to remove dust and
dirt from the filter.
維護方法
HOW TO MAINTENANCE
26
To Next Page