熱/涼乾燥功能的使用方法
HOW TO USE DRY HOT/COOL FUNCTION
使用乾燥功能進行衣物 烘 乾時，建議按照下圖進 行 安裝:
浴室牆壁或地板殘留水 滴 時，會導致衣物乾燥時 間 延長，請事前用乾布等 擦 拭乾淨。
為使溫風遍佈，衣物間 要 保留間隔(50 mm以上)。
厚衣物掛在溫風出風口 附 近會更易乾。
衣物離出風口必須保證 在200 mm以上。(如果太近可能會導致衣物變 色)
密閉性、斷熱性不好的 浴 室，因產品的性能不能 充 分發揮，請將乾燥時間 適 當設置長一點。
乾燥時間會因浴室的大 小 、種類、室溫、外界溫 度 、濕度、衣物種類、數 量 、脫水狀態而不同。
衣桿後端的衣物不易乾 ， 在乾燥中途可將易乾的 靠 近產品端的衣物與後端 衣 物調換位置。
(風向自動時，如圖所示 中 央約1100 mm為風易吹到的範圍。)
To use the drying function to dry clothes, you are suggested to install the product as
shown below:
When water drops remain on the bathroom walls or the floor, the clothes drying
time will be prolonged. Use a dry cloth to wipe away water drops in advance.
To spread the warm airflow, keep a space (more than 50 mm) between clothes.
The drying time varies with the bathroom size and type, room temperature, outside
temperature and humidity, clothes types and quantities, and the dewatering status.
Hang heavy clothing near the warm airflow outlet to dry them more quickly.
Since the product performance cannot be fully brought into play in the bathroom
with poor airtight and heat resistance, you need to set a longer drying time .
The clothes at the back end of the clothesline pole cannot be dried quickly. In the
midway of drying, you can swap the positions of fast-drying clothes near the product
with those at the back end. (In the case of Auto air direction, the scope of about
1100 mm at the center is easily reached by the airflow, as shown in the figure.)
The clothes must be 200 mm or above away from the air outlet. (The clothes may
be discolored if the distance is too short.)
Do not hangtheclothesonproductdirectlytodry.
請勿把衣物直接掛在產品 上乾燥。
提示事項
Notice
20
50
50
5
0
5
0
5
0
5
0
50
5
0
Unit: mm
單位：mm
範
為使乾 衣效果更好，建議在門下部
設置有 效開口面積應在100 cm²以上
的換氣 用百葉窗。
To make the effect of drying
clothes better, please set a
ventilation shutter at the lower
part of the door with a valid
opening area of 100 cm² or above.
To Next Page