9
URL : http://panasonic-electric-works.net/sunx
Overseas Sales Division (Head Office)
2431-1 Ushiyama-cho, Kasugai-shi, Aichi, 486-0901, Japan
Phone: +81-568-33-7861 FAX: +81-568-33-8591
Europe Headquarter: Panasonic Electric Works Europe AG
Rudolf-Diesel-Ring 2, D-83607 Holzkirchen, Germany
Phone: +49-8024-648-0
17 SPECIFICATIONS
Item Connector type Cable type
FX-301 (NPN) FX-301-C1 (NPN)
FX-301P (PNP) FX-301P-C1 (PNP)
Supply voltage 12 to 24V DC ± 10% Ripple P-P 10% or less
Power consumption
• Normal operation: 960mW or less
(Current consumption 40mA or less at 24V supply voltage)
• ECO mode: 600mW or less
(Current consumption 25mA or less at 24V supply voltage)
Output
NPN output type
NPN open-collector transistor
• Maximum sink current: 100mA
*1
• Applied voltage: 30V DC or less (between output
and 0V)
• Residual voltage: 1.5V or less (at 100mA
*1
sink
current)
*1
50mA, if five or more connector type FX-301(P) amplifiers are connected in cascade.
PNP output type
PNP open-collector transistor
• Maximum source current: 100mA
*1
• Applied voltage: 30V DC or less (between output
and +V)
• Residual voltage: 1.5V or less (at 100mA
*1
source
current)
Output operation Light-ON or Dark-ON, selectable
Short-circuit protection Incorporated
Response time
*2
*2
Select in PRO1 mode. See “PRO1” on page 6.
• H-SP 65μs or less
• FAST: 150μs or less
• S-D: 250μs or less
• STD: 250μs or less
• LONG: 2ms or less
Display 4-digit red LED display
Sensitivity setting 2-point teaching, limit teaching, full-auto teaching, manual adjustment
Sensitivity adjustment function
*3
*3
See “THRESHOLD VALUE ADJUSTMENT MODE” on page 5.
Incorporated.
Timer function
Incorporated. Available modes: off, ON-delay, OFF-delay, ONE-SHOT timer.
Timer interval range: approx. 0.5 to 9999ms.
Interference prevention function
Incorporated. Up to four fibers can be mounted adjacently.
For the H-SP response time, the maximum is two fibers.
*4
*4
When the power supply is switched on, the light emission timing is automatically set for interference prevention.
Ambient temperature
• 1 to 3 units mounted in cascade: -10 to +55°C
• 4 to 7 units mounted in cascade: -10 to +50°C
• 8 to 16 units mounted in cascade: -10 to +45°C
• No dew condensation or icing allowed
• Storage: -20 to +70°C
Ambient humidity 35 to 85% RH, Storage: 35 to 85% RH
Emitting element Red LED (modulated)
Material
Enclosure: Heat-resistant ABS, Transparent cover: Polycarbonate
Mode key: Acrylic, Jog switch: Heat-resistant ABS
Cable – 0.3mm² 3-core cabtyre cable, 1m long
Weight Approx. 20g Approx. 60g
Accessory
FX-MB1 (Amplifier protection seal): 1 set
*5
*5
Cables for connecting the amplifiers are not supplied as an accessory. Make sure to use the following optional quick-connection cables:
Main cable (3-core): CN-73-C1 (cable length 1m), CN-73-C2 (cable length 2m), CN-73-C5 (cable length 5m)
Sub cable (1-core): CN-71-C1 (cable length 1m), CN-71-C2 (cable length 2m), CN-71-C5 (cable length 5m)
To Previous Page
Loading...
