Panasonic GT05

10-3
10.2 Modbus (RTU Mode)
PLC model selection
Device setting: Start No. *****0
Select "Modbus (RTU Mode)".
Usable devices
Bit/Word Device
No.
Memo
Bit Device
Input
100000-165535
Coil
000000-065535
Word Device
Input
100000-165535
Specify address expression every 16 multiples
Coil
000000-065535
Specify address expression every 16 multiples
Input Register
300000-365535
Holding Register
400000-465535
Communication Parameters Settings
The example of communication settings of GT and PLC is shown below.
Setting Values for GT (Set in the configuration setting of GTWIN.)
Item
Setting
PLC Unit No.
1
Baud Rate
19200bps
Length of Bits
8
Stop Bits
1
Parity
Even
Setting Values for PLC
Item
Setting
Station Address
1
Mode
RTU
Baud Rate
19200bps
Length of Bits
8
Stop Bits
1
Parity
Even
Other companies' PLCs to be used
Make sure to check on the actual equipment to be used.
PLC checked on the actual equipment: DL05 made by Koyo Electronics Industries Co., Ltd