Panasonic HC-V180 - Page 35

- 35 -
The firmware version of this unit is displayed.
You can update the firmware version of this unit.
This item is used to start the unit demonstration.
≥ If [DEMO MODE] is switched to [ON] and you touch [EXIT] when there is no SD card inserted and
while this unit is connected to the AC adaptor, the demonstration automatically starts.
If any operation takes place, the demonstration is canceled. However if no operations take place
for approx. 10 minutes, the demonstration automatically starts again. To stop the demonstration,
set [DEMO MODE] to [OFF] or insert an SD card.
This item is used to start the Optical Image Stabilizer demo.
≥ Touch [O.I.S. DEMO], the demonstration automatically starts.
When you touch [EXIT], the demonstration will be canceled.
This item is displayed only when an Eye-Fi card is inserted.
Please refer to page 104.
This item is displayed only when an Eye-Fi card is inserted.
Please refer to page 105.
[Firmware Version Info]
: [SETUP] # [Firmware Version Info]
[Firmware Upgrade]
: [SETUP] # [Firmware Upgrade]
For the latest update information, check the support website below. (As of November
2015)
http://panasonic.jp/support/global/cs/e_cam
(This Site is English only)
[DEMO MODE]
: [SETUP] # [DEMO MODE] # [ON]
[O.I.S. DEMO]
: [SETUP] # [O.I.S. DEMO]
[Eye-Fi TRANSFER]
[Eye-Fi DIRECT]
MENU
MENU
MENU
MENU