34
SQT1160 (ENG)
Please refer to “Operating Instructions (PDF format)” for details.
Recording
Problem Check points
Colour or brightness of
the image changes, or you
may see horizontal bars in
the image.
The LCD monitor flickers
indoors.
≥ Colour or brightness of the image may change, or you may
see horizontal bars in the image when the object is recorded
under fluorescent light, mercury light or sodium light, etc., but
this is not a malfunction.
≥ In Motion Picture Recording Mode, record in Intelligent Auto
Mode/Intelligent Auto Plus Mode or set the shutter speed as
follows:
j When [REC FORMAT] is set to [24p]:
Set to 1/50 seconds in areas where the power supply
frequency is 50 Hz, or 1/60 seconds in areas where the
frequency is 60 Hz.
j When [REC FORMAT] is set to a setting other than [24p]:
Set to 1/100 seconds in areas where the power supply
frequency is 50 Hz, or 1/125 seconds in areas where the
frequency is 60 Hz.
≥ In Still Picture Recording Mode, this will not affect the
recorded image.
≥ In the following cases, setting the shutter speed to
1/100 seconds reduces the intensity of the problem:
j In FULL HD Slow Motion Mode
j (For the series/ )
Slow & Quick Video Mode
Playback
Problem Check points
Scenes/still pictures
cannot be played back.
≥ Any scenes/still pictures where the thumbnails are displayed
as cannot be played back.
Simplified-HC-WXF990&VXF990&VX980_GC&GW&GN&GH-SQT1160_mst.book 34 ページ ２０１６年１月１４日 木曜日 午後３時２
To Next Page
Loading...
