Panasonic HG-C1000L Series - 1-point teaching (window comparator mode); Limit teaching; 2-point teaching (window comparator mode)

3
2. Press the TEACH key when the sensing
object is present.
(System command / Index2: 0x4D)
Stable sensing is possible.
Stable sensing is not possible.
Limit teaching
This teaching method is recommended, if small objects or objects in the
background exist.
When an object in the background is used as reference:
Distance
Background
UP key
Threshold
Teaching value
When a sensing object is used as reference:
Distance
Sensing object
DOWN key
Threshold
Teaching value
1. Press the TEACH key when the back-
ground or the sensing object is present.
(System command / Index2: 0x4D)
A
utomatic
2. When an object in the background is used
as reference, press the UP key to set the
threshold on the sensor side.
(System command / Index2: 0x4B)
When a sensing object is used as a refer-
ence, press the DOWN key to set the
threshold on the sensing object side.
(System command / Index2: 0x4C)
3. Teaching is completed.
1-point teaching (window comparator mode)
This mode is used for setting the threshold range for the distance from the
reference value of the sensing object by performing a 1-point teaching. This
mode is used for sensing within the threshold range.
When performing the 1-point teaching (window comparator mode), preset
“Window comparator mode 1” in the sensing output setting of the PRO
mode. For the setting method, refer to section 13, “PRO mode setting.”
ON
OFF
OFF
Sensing object
Threshold 2_SL
Reference surface
Threshold 1_SL
1. Press the TEACH key twice when the
sensing object is present.
(System command / Index2: 0x4D; Two
times)
2. Teaching is completed.
2-point teaching (window comparator mode)
This method is used to set the threshold range by conduction the 2-point
teaching.
When performing the 2-point teaching (window comparator mode), preset
“Window comparator mode 2” in the sensing output setting of the PRO
mode. For the setting refer to section 13, “PRO mode setting.”
When conducting the teaching, use sensing objects (P-1 and P-2) whose
distance are di󰀨erent from each other.
Distance
Sensing object
P-1
Sensing object
P-2
2nd time (Threshold 2_SL)
1st time (Threshold 1_SL)
Threshold surface
ON
OFF
OFF
1. Press the TEACH key when the sensing
object P-1 is present (1st time).
(System command / Index2: 0x4D)
2. Press the TEACH key when the sensing
object P-2 is present (second time).
(System command / Index2: 0x4D)
Stable sensing is possible.