36 VQT3P12
SETUP
1 Image stabilizer (page 67)
h Compensate for camera shake
during recording.
2 Focus (page 68)
h Adjust the focus according to
the distance to the subject.
3 Focus mode
4 Metering mode
5 ISO sensitivity (page 69)
h The indicated ISO value is the
standard output sensitivity.
6 White balance (page 70)
7 Remaining battery power
indication (page 114)
: During video recording, the
image stabilizer is always
active.
: Camera shake in the
captured photo is
corrected.
: Camera shake during video
and photo recording is
compensated for and
corrected.
: The image stabilizer is not
active.
*: The camera automatically
focuses on the subject with
a range of 10 cm (3.9”) to ∞
(normal).
-: The focus can be set
manually.
: The camera focuses on the
subject within a range of
1 cm (0.4”) to ∞ (macro).
: 9-point range finder focus
: Spot focus
A focus mark ' appears in
the center of the LCD
monitor.
n: Multi-metering
W: Center-weighted light
measuring
Y: Spot light-measuring
A metering spot @ mark
appears in the center of the
LCD monitor.
=: Sensitivity is set
automatically
*: Sets sensitivity to ISO 50
u: Sets sensitivity to ISO 100
v: Sets sensitivity to ISO 200
w: Sets sensitivity to ISO 400
6: Sets sensitivity to ISO 800
-: Sets sensitivity to ISO 1600
z: Set sensitivity to ISO 3200
(HX-DC10)
>: White balance is
automatically adjusted
depending on the ambient
lighting (auto).
: For shooting in sunny
conditions (sunny).
o: For shooting in overcast
conditions (cloudy).
: For shooting under
incandescent lighting
(incandescent).
: For setting the most
accurate white balance
(white set).
To Next Page
Loading...
