1.2 Making Calls
User Manual 25
To select the specified outside line
Making a Call to a Private Network (TIE Line Access)
You can access extensions connected to other PBXs in a private network.
To call
• Each of the S-CO button or G-CO button light shows the current status as follows:
Off: The line is idle.
Red on: The line is in use.
• You may be restricted from making a call to the specified outside party. To make a call, refer
to "1.2.7 Calling without Restrictions".
• To confirm number before dialling, you can enter a phone number and confirm it on the
display and then go off-hook. (Predialling)
• Call Charge Reference
You can confirm your total call charges by pressing the Charge Reference button.
• To make a call to another party without going on-hook, press the FLASH/RECALL button.
It will re-access the outside line and provide external dial tone. Pressing the Terminate button
will provide intercom dial tone. You can dial the new phone number without going on/off-hook.
Customising Your Phone
• 3.1.2 Settings on the Programming Mode–Preferred Line Assignment—Outgoing
Select the seized line when going off-hook.
• 3.1.3 Customising the Buttons
Create or edit a Loop-CO (L-CO) button, a Group-CO (G-CO) button, a Single-CO (S-
CO) button, a Terminate button or a Charge Reference button.
PT and
PT/PS
Off-hook.
Talk.Press
S-CO
.
(S-CO)
Dial
outside phone
number
.
outside
phone no.
PT/SLT/PS
Off-hook.
Talk.
Enter 7. Dial private phone
number.
private phone no.
7
To Next Page
Loading...
