Panasonic KV-S1027C - Page 42

42
Remarks
1. Parameter setting by user
2. Status indication
3. Parameter setting by service person
4. Adjustment
5. Diagnosis
6. Maintenance
Note
*1: These items are also available in the User Utility software.
*2: This setting is needed when replacing CONTROL Board or EEPROM (IC28).
*3: Error Contents (Error Log sample)
1:Date
2:Time
3:Model
4:USB ID
5:Error Contents + Error detail
6:Error Code
7:System counter
8:Flatbed counter
9:Counter after roller cleaning
10:Counter after rollers replacement
11:Not assign
12:Error message or Counter clear history
ON or OFF appears in two cases below.
1. Clean Roller Counter or Replace Roller Counter is reset.
2. Double Feed or Dog-ear is detected.
1st ON/OFF : Setting of Roller Cleaning Notification
2nd ON/OFF : Setting of Roller Replacement Notification
*Rename the file from "Scanner.log" to "Scanner.csv" to make the log history more visible.
201410/02,10:05,KV-S1057C ,Z20140818161229,0x-,-,1075,0,1075,1075,0,ON,ON, Double Feed Skip Detected.(1)
2014/10/14,15:04,KV-S1057C ,Z20140818161229,0x11000000,U11,5574,0,5574,5574,0,A paper jam has occurred.
2014/10/17,16:50,KV-S1057C ,Z20140818161229,0x,,6017,0,6017,6017,0,The rollers need to be cleaned.
2014/10/17,16:56,KV-S1057C ,Z20140818161229,0x-,-,6017,0,6017,6017,0,ON,ON, Clean Roller Counter was reset to 0
2014/10/23,13:13,KV-S1057C ,Z20140818161229,0x50000000,U60,8089,0,2072,8089,0,System error occurred.
1 2 3 4 5 6 7 8 9 10 11 12