Push scan using the 7-segment LED
If you are using a KV-SL1066, KV-SL1056, KV-SL1055, KV-SL1036 or KV-SL1035 with Image Capture Plus,
you can perform a push scan using the 7-segment LED. A registered job number is displayed on the 7-segment
LED. Use the cursor button (A) to select a job number.
Note
• Register jobs in advance. For details about registering jobs, refer to the Image Capture Plus help.
1. Place the documents on the feed tray.
2. Use or of the cursor button (A) to select a job number.
3. Press the Start/Stop button (B).
• Scanning will start.
44 Operating Manual
Operation
To Next Page
Loading...
