2. Preparation
15
For assistance, please visit http://www.panasonic.com/help
2 Preparation2For assistance, p lease visit http ://www.panasonic.com/helpConnecti ons and Setup
2.1 Connections
Caution:
L When you operate this product, the power outlet
should be near the product and easily
accessible.
Note:
L If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
Using surge protectors
L The warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using surge protectors (9).
If the unit shares a single telephone line with a DSL
service
Fax transmission/reception may be disturbed, noise
interference may be heard during telephone
conversations, or Caller ID (page 47) may not function
properly. A filter to prevent this is provided by your
provider. Please attach the filter (j) to the telephone
line cord of the unit.
1 Power cord
L Connect to a power outlet
(120 V, 60 Hz).
2 Telephone line cord
L Connect to a single telephone line jack (RJ11).
3 [EXT] jack
L You can connect an answering machine or an
extension telephone. Remove the stopper if
attached.
4 Answering machine (not supplied)
5 Handset unit (optional) connection jack
L You can connect the optional handset unit (page
66). Remove the seal if attached.
6 Network router/Network hub (not supplied)
L Also connect networked computers.
7 To the internet
8 LAN cable (not supplied)
L To assure continued emission limit compliance,
use only shielded LAN cable (category 5 straight
cable).
7
8
3
6
1
9
4
2
5
Important notice for the USB connection
L Do NOT connect the USB cable until prompted by
the Multi-Function Station (page 22).
j
To Next Page
Loading...
