9. Programmable Features
56
Setting the output tray to use
for faxing
{#}{4}{4}{1}
You can select the output tray that will be used for printing received faxes.
{1} “#1”: Upper output tray (Up to approx. 100 sheets)
{2} “#2” (default): Lower output tray (Up to approx. 50 sheets)
Note:
L Lists or reports printed by pressing {HELP} (page 18) or {MENU} (page 88)
will be stacked on the upper output tray.
Receiving a fax into the
computer
{#}{4}{4}{2}
If you wish to receive a fax into the computer, activate this feature and run [PC
FAX] from Multi-Function Station.
{0} “OFF” (default): Deactivates this feature.
{1} “ALWAYS”: If the unit recognizes the connection to the computer, it will
transfer a received document to the computer. If the unit cannot recognize the
connection, it will store a received document in the memory once, then transfer
the data after recognition of the connection.
{2} “CONNECTED”: If the unit recognizes the connection to the computer, it will
transfer a received document to the computer. If the unit cannot recognize the
connection, it will print out the data.
Setting the computer for PC
fax reception
{#}{4}{4}{3}
To select the computer that will be used for receiving a fax. See page 21 for
details.
Resetting fax features to their
default settings
{#}{4}{5}{9}
{0} “NO” (default)
{1} “YES”
To reset the fax features:
1. {MENU} i {#}{4}{5}{9}
2. Press {1} to select “YES”. i {SET} i {SET} i {MENU}
Note:
L The PC fax reception (feature #443 on page 21) will not be reset.
Feature/Code Selection
To Next Page
Loading...
