Panasonic KX-FP205

7. Programmable Features
41
Setting the memory
reception alert
{#}{4}{4} To alert you with a beeping sound when a received fax document
is stored into memory due to some existing problem.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): You will hear a beeping sound.
Note:
L The slow beeps will continue until you clear the printing
problem and make sure the unit is supplied with enough paper
to print the stored document.
Setting friendly
reception
{#}{4}{6} To receive a fax automatically when you answer a call and hear a
fax calling tone (slow beep).
{0} “OFF”: You have to press {FAX START} for fax reception.
{1} “ON” (default): You do not have to press {FAX START} for fax
reception.
Setting the voice
guidance (KX-FP215
only)
{#}{4}{7} If you wish to hear voice guidance, activate this feature.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): You will hear the friendly reception voice guide,
pre-recorded messages and voice time/day stamp.
Setting the auto
disconnection
{#}{4}{9} To answer a call with an extension telephone in TEL/FAX mode
(page 27) or TAM/FAX mode (page 28), activate this feature and
program the code.
{0} “OFF”
{1} “ON” (default)
1. {MENU} i {#}{4}{9}
2. Press {1} to select “ON”. i {SET}
3. Enter your code from 2 to 4 digits, using 0–9 and {*}.
L The default code is “;0”.
4. {SET} i {MENU}
Changing the recording
time for your TAM/FAX
greeting message (KX-
FP215 only)
{#}{5}{4}{1} “16s” (default): Maximum recording time is 16 seconds.
{2} “60s”: Maximum recording time is 60 seconds.
See page 33 for details.
Setting the scan
contrast
{#}{5}{8} To send or copy a document with faint or dark writing, set this
feature before transmission or copying.
{1} “NORMAL” (default): Used for normal writing.
{2} “LIGHT”: Used for dark writing.
{3} “DARKER”: Used for faint writing.
Setting the incoming
message monitor (KX-
FP215 only)
{#}{6}{7} To hear an incoming message (ICM) from the speaker when the
answering machine is recording the message.
{0} “OFF”
{1} “ON” (default)
Setting the Error
Correction Mode (ECM)
{#}{6}{8} This feature is available when the transmitting/receiving fax
machines are ECM compatible.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): If there is an error during fax
transmission/reception, the fax machine will support the
communication.
Note:
L You cannot change the setting when received documents are
in memory.
Feature Feature code Selection
FP205-215E-PFQX2485ZA-en.book Page 41 Wednesday, April 26, 2006 6:34 PM