Operating Instructions
[For assistance, please call: 1-800-272-7033] 99
4.1.2 Mounting on the Ceiling
Mount Network Camera at an even place where vibrations etc. are few. Set the Tilt
range to [On the ceiling] on Camera Setup window on page 84. Two ways of
wiring can be considered; wiring through a hole made in the ceiling or wiring
without making a hole for a cable in the ceiling. Select either one of the two.
Wiring through a hole made in the ceiling
1.
Fix the Ceiling Plate B on the ceiling with Screws B.
• Fix the Ceiling Plate B more than 100 mm (4 inches) off the wall or other
obstacles from its center.
• Make sure Network Camera is firmly mounted on a beam of wood etc.
When there is no beam, apply a board on the other side of the ceiling to
make sure Network Camera does not drop.
Screws B (4 pcs.)
Keep more than 100 mm
(4 inches) off the wall or
other obstacles.
Network Camera
Direction
100 mm
(4 inches)
To Next Page
Loading...
