To Next PageTo Next PageHow to fix a blank display on my Panasonic IP Phone?
If your Panasonic IP Phone display is blank, it's likely not receiving power. This phone isn't designed to work during power failures. Check that the device providing PoE is powered on and the Ethernet cable is properly connected. If you're using an AC adapter, verify it's connected and receiving power.
What to do if my Panasonic IP Phone doesn't ring?
If your Panasonic IP Phone is not ringing when you receive a call, the ringer may be turned off. To resolve this, press the [j] volume key while a call is being received, or adjust the ringer volume setting.
How to fix Bluetooth headset issues on Panasonic IP Phone?
If you cannot have a conversation using the Bluetooth headset with your Panasonic IP Phone, ensure the headset is properly registered to the unit. If an EHS headset is connected, remove it from the headset jack. Also, make sure that the headset is properly charged.
Why does the sound cut out on my Panasonic IP Phone?
If the sound cuts out or you hear yourself through the speaker on your Panasonic IP Phone, try speaking closer to the microphone. Also, ensure the unit is not within 2 m (6 ft 7 in) of projectors, air conditioning, fans, or other noise-emitting devices. Close curtains or blinds to prevent echoes, and avoid moving the unit during a call. Ensure nothing is obstructing the microphone. If the other party is using a half-duplex speakerphone, sound may cut out occasionally.
What to do if I can't edit phonebook on Panasonic IP Phone?
If you cannot add or edit entries to the phonebook list on your Panasonic IP Phone, it may be because the phonebook list is full. Delete any unnecessary entries. The maximum number of entries in the phonebook list is 2500.
What does the Message/Ringer lamp indicate on Panasonic IP Phone?
If the Message/Ringer lamp is lit on your Panasonic IP Phone, it indicates that you received a voice message while you were on the phone or away from your desk. Check the voice message.
How to turn on a KX-HDV20 Panasonic IP Phone?
To resolve the issue where the KX-HDV20 Panasonic IP Phone will not turn on, connect the KX-HDV330 to an AC power outlet using the optional AC adaptor, as it may be receiving power via Power-over-Ethernet (PoE).
Why can't I hear a dial tone on my Panasonic IP Phone?
If you cannot hear a dial tone on your Panasonic IP Phone, confirm that the LAN cable is properly connected.
Why does my Panasonic IP Phone disconnect during calls?
If you are talking to an outside party and the line is disconnected on your Panasonic IP Phone, your phone system/service may impose a time limit on outside calls.
What to do if I can't cancel phonebook lock on Panasonic IP Phone?
If you cannot cancel the phonebook lock on your Panasonic IP Phone, ensure you enter the correct password.
General| Type | IP Phone |
|---|---|
| Power over Ethernet | Yes |
| Speakerphone | Yes |
| Headset Jack | Yes |
| Bluetooth | No |
| Speakerphone Type | Full-duplex |
| Audio Codec | G.711, G.722, G.729 |
| Ethernet Ports | 2 x 10/100/1000 Mbps |
| Headset Jack Type | RJ9 |
| Voice Codecs | G.711, G.722, G.729 |
