2 E
nter the password. a MOKN
Note:
R By pressing MDISARMN, you can disarm the
security system and stop the alert. See
“Arming and disarming the system”,
page 37.
Displaying sensor status
T
he status of each sensor device is shown on
the handset.
1 MMENUN#801
2 MbN: Select “All locations” or the
area in which the desired sensor devices
belong to. a MSELECTN
3 MbN: Select the desired sensor.
R Press MREFRESHN to refresh the
displayed information.
Talking notification feature
T
his feature allows you to get information
about a triggered sensor without looking at the
display. When a sensor is triggered, the
handset can announce the location of the
sensor detected, the sensor name, and the
type of detection. The announcement is heard
before the alert sounds. The default setting is
“On”.
1 MMENUN#809
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
Alert volume
You can adjust the alert volume heard during
At Home mode and Away mode.
– “Alert volume”: The volume of the alert
that sounds when the system is not
disarmed within the entry delay time
(page 37).
– “Entry alert volume”: The volume of
the alert that sounds during the entry delay
time (page 37).
– “Exit alert volume”: The volume of
alert that sounds during exit delay time
(page 37).
n
Changing alert volume
1 For handset:
MMENUN#803 (At Home) or
MMENUN#804 (Away)
For hub:
MMENUN#*803 (At Home) or
MMENUN#*804 (Away)
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
n Changing entry alert volume
1 For handset:
MMENUN#808 (At Home) or
MMENUN#807 (Away)
For hub:
MMENUN#*808 (At Home) or
MMENUN#*807 (Away)
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
n Changing exit alert volume
1 For hub:
MMENUN#805 (Away)
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
Setting/changing the disarm PIN
Y
ou must enter the disarm PIN in order to
disarm the security system. The default PIN is
“0000”. We recommend changing the disarm
PIN.
Important:
R When you change the disarm PIN, please
make note of the new PIN. The unit will not
reveal the PIN to you. If you forget the PIN,
contact an authorized service center.
1 MMENUN#810
2 Enter the current disarm PIN (4-8 digits).
a MOKN
R Skip this step when setting the disarm
PIN for the first time.
3 Enter the new disarm PIN (4-8 digits). a
MOKN
4 Re-enter the new disarm PIN. a MSAVEN
38
For assistance, please visit www.panasonic.com/support
Home Network System Integration
To Next Page
Loading...
