Home Network System
i
ntegration
If you have other devices registered to the
hub, such as cameras, sensors, and smart
plugs, you can use the handset as an
integrated part of the Home Network System.
Specifically, you can use the handset to:
– arm and disarm the system’s security
features (page 37).
– receive notifications when the sensors are
triggered.
– display the status of each sensor
(page 38).
– turn smart plugs on and off (page 39).
Security features
Y
ou can use the handset to arm and disarm
the system’s security features. If the system’s
sensors are triggered when the system is
armed, such as when motion is detected or
when a door or window is opened:
– the handset and hub sound an alert.
– the handset displays information about the
detection.
– the handset announces the detection.
(Talking notification feature; page 38)
– the hub LED indicator blinks in red.
– the M
N
button on the handset blinks.
Additional features and settings are available
when using the Home Network app
(page 39).
Arming and disarming the
system
The security system has 3 modes.
– “At Home”: Door and window sensors are
armed.
*1
– “Away”: All sensor devices are armed.
*1
– “Disarm”: All sensor devices are disarmed.
R The hub LED indicator lights in red when
the security mode is set to “At Home” or
“Away”.
*1 Default settings. These settings can be
c
hanged when using the Home Network
app. For more information, refer to the
User’s Guide (page 40).
n To arm the system:
1 M
N
2 MbN: Select “At Home” or “Away”. a
MSELECTN
R If the system is indicating that it has
been triggered (such as when the alert
is sounding), the mode cannot be
changed to “At Home” and “Away”.
3 Enter the password if prompted. a MOKN
R If you have not change the PIN from
the default PIN, the handset will
prompt you to change it (page 38).
R When you select “Away”, you need to
press MOKN to activate the mode. The
hub sounds an alert for 3 minutes; this
gives you time to leave home before
the sensors can be triggered (Exit
delay time). The sensors will be armed
when the alert stops.
Note:
R If the system detects that a window or door
is still open when you arm the security
system, the handset will notify you. Close
the window or door and then press MOKN.
n To disarm the system:
1 MDISARMN
2 MbN: “Disarm” a MSELECTN
3 Enter the password. a MOKN
Note:
R By default, after door sensors and motion
sensors make a detection, the system gives
you 3 minutes to disarm the system (Entry
delay time). During this time, the entry
delay alert will sound. If you do not disarm
the system in time, the sensors are
triggered and the security alert sounds.
Stopping the alert
W
hen a sensor is triggered, the hub and
handset sound an alert. Use the following
procedure to stop the alert.
1 Press MSTOPN or MOFFN.
For assistance, please visit www.panasonic.com/support
37
Home Network System Integration
To Next Page
Loading...
