11.2 Cordless handset programming (KX-MB2060 optional)
To access the features, there are 2 methods:
– scrolling through the display menus (page 99)
– using the direct commands (page 100)
R Direct command is the main method used in these operating instructions.
11.2.1 Cordless handset features
Programming by scrolling through the display menus
1. MMENUN (soft key A)
2. Press MCN or MDN to select the desired main menu.
A MSELECTN (soft key A)
3. Press MCN or MDN to select the desired item in
sub-menu 1. A MSELECTN (soft key A)
R In some cases, you may need to select from
sub-menu 2. A MSELECTN (soft key A)
4. Press MCN or MDN to select the desired setting. A
MSAVEN (soft key A)
R This step may vary depending on the feature
being programmed.
R To exit the operation, press MOFFN.
Top-menu Sub-menu 1 Sub-menu 2 Feature (default setting)
“Caller list” – – page 55
“Answering
device”
“Play new msg.” – Play new messages: page 75
“Play all msg.” – Play all messages: page 75
“Erase all msg.” – Erase all messages: page 75
“Greeting” “Record greeting” Record greeting message:
page 74
“Check greeting” Play greeting message: page 74
“Pre-recorded” Reset to pre-recorded greeting
message: page 74
“Settings”
“Ring count”
*1
Change the ring count (“2
rings”): page 76
“Recording time” Change the maximum recording
time (“3 min”): page 76
“Remote code” Set the remote operating ID
(“111”): page 76
“Answer on” – Turn the answering machine ON:
page 62
“Answer off” – Turn the answering machine OFF:
page 64
“V. M. access”
*2
– – Voice mail access
“Intercom” – – Intercom call: page 104
“Set date & time”
“Date and time”
*1
– Date and time: page 28
“Alarm” – Set the alarm (“Off”): page 103
99
11. Programmable Features
To Next Page
Loading...
