Feature Code Description
Default
key
Paper size in the
manual tray
#381 To set the recording paper size in the manual tray.
Note:
R If you have set feature #147 to “INCHES”, the numbers are
displayed in inches.
–
Paper type for the
standard input
tray
#383 To set the recording paper type for the standard input tray.
Note:
R This setting will be deactivated when printing from a computer. To
set the recording paper type for printing, see page 50.
M1N
Paper type for the
manual tray
#384 To set the recording paper type for the manual tray.
Note:
R This setting will be deactivated when printing from a computer. To
set the recording paper type for printing, see page 50.
M1N
Power save #403 To set the length of time before the unit enters power save mode.
Note:
R During power save mode, the unit needs to preheat the fuser unit
before it can begin printing.
M1N
Contrast hold #462 To hold the previous contrast setting.
Note:
R This feature is not available for scanning contrast.
M0N
Default operation
mode
#463 To select the default operation mode (copy or fax) when the selected
time of the mode timer (feature #464) elapses.
Note:
R You cannot select scan mode using this feature.
M1N
Mode timer #464 To set the timer before returning to the default operation mode
(feature #463).
M2N
QUICK-JOB
priority for copy
#478 The selected job will be displayed first.
M1N
Counter view for
departments
#479 To view the count number of copies/prints for departments. See
page 97 for details.
–
Toner save #482 To set the toner save feature. When this feature is activated, the toner
cartridge will last longer.
Note:
R This feature may lower the print quality by reducing toner
consumption.
R This setting is valid for copying, and when the unit prints reports/
lists.
R This setting is invalid for printing received faxes (fax supported
models only). (y)
M0N
QUICK-JOB
priority for scan
#497 The selected job will be displayed first.
M1N
3.7 Programming through a web browser (LAN supported models
only) y
You can change features through the web browser interface instead of the unit.
1 Start Multi-Function Station. A [Device] A [Configuration Web Page]
R You can also access the unit by entering its IP address in a web browser.
41
3. Basic Operations
To Next Page
Loading...
