Panasonic KX-NS0154

39
KX-NS0154
D3 MEMXA14_BA1_LCDD8 not used O
D4 MEMXA16 not used O
D5 DDRDQ9 DDR Data I/O
D6 DDRDQ13 DDR Data I/O
D7 DDRDQ15 DDR Data I/O
D8 DDRDM0 DDR Data Mask O
D9 DDRRST_N DDR Reset Active Low (Not used) O
D10 DDRCKE DDR Clock Enable O
D11 DDRBA0 DDR Bank Address Bus O
D12 VDD 1.2 V Core PI
D13 DDRA4 DDR Command/Address Bus O
D14 DDRA9 DDR Command/Address Bus O
D15 DDRA11 DDR Command/Address Bus O
D16 DDRA13 DDR Command/Address Bus (Not used) O
D17 SPI2DI SPI2 Serial Data In I
D18 SPI2CK SPI2 Clock O
D19 D1RX TDM1 RX Data I
E1 MEMXA20_MEMRAS_LCDD16 not used O
E2 MEMXA9_LCDGP6 not used O
E3 MEMXA8_LCDGP5 not used O
E4 MEMRD not used O
E5 VDD 1.2 V Core PI
E6 VDD 1.2 V Core PI
E7 VDDIO_DDR DDR I/O PI
E8 VDD 1.2 V Core PI
E9 GND GND Connection GND
E10 VDDIO_DDR DDR I/O PI
E11 PLL2_DVDD PLL2 Digital PI
E12 E_VDDRQ 2.5 V Power Supply for Filtering (Not usd) PO
E13 PLL1_DVDD PLL1 Digital PI
E14 DDRPADLO DDR Low Drive Strength I
E15 SPI1CK SPI1 Clock O
E16 DDRPADHI DDR High Drive Strength I
E17 SPI1DO SPI1 Serial Data Out O
E18 F1SYNC TDM1 Frame Sync I
E19 XI25M Clock input (13.824MHz for internal clock) I
F1 MEMCKE_EXTINT13 not used O
F2 MEMXA19_MEMCAS_LCDD9 not used O
F3 MEMXA11_LCDGP8 not used O
F4 MEMXA15 not used O
F5 VDDIO_DDR DDR I/O PI
F6 VDDIO_DDR DDR I/O PI
F7 VDDIO_DDR DDR I/O PI
F8 VDDIO_DDR DDR I/O PI
F9 VDDIO_DDR DDR I/O PI
F10 VDDIO_DDR DDR I/O PI
F11 PLL2_AVDD PLL2 Analog PI
F12 PLL1_AVSS PLL1 Analog GND P
F13 PLL1_AVDD PLL1 Analog PI
F14 SPI1CS0 SPI1 CS O
F15 D1TX TDM1 TX Data O
F16 TEST Test Mode Select (Not used) I
F17 T1SCLK TDM1 SCLK I
F18 TRST JTAG Reset I
F19 XO25M 25 MHz Crystal Feedback (Not used) O
G1 MEMCLK Memory Clock (Not used) O
G2 MEMXA12_EXTINT14 Memory Address (Not used) O
G3 MEMCS0_LCDD0 not used O
G4 MEMCS1_LPCLK not used O
G5 VDDIO General I/O PI
G6 GND GND Connection P
G7 GND GND Connection P
G8 GND GND Connection P
G9 GND GND Connection P
G10 GND GND Connection P
G11 VDDIO_DDR DDR I/O PI
G12 PLL2_AVSS PLL2 Analog GND P
Pin No. Terminal Name Contents of Control I/O setting Remark