Setting the Date & Time
1. Press [MENU].
2. Select "Basic Settings", then press
.
3. Select "Date & Time", then press
.
4. Using the keypad, enter 2 digits each for the year,
month, day of the month, hour (24-hour format), and
minute.
5. Press
.
6. Press [MENU].
Operation Mode
By selecting an operation mode, the unit operates as a
SIP extension of the PBX, peer to peer IP conferencing
phone or USB audio device of a computer.
1. Press [MENU].
2. Select "Operation Mode", then press
.
3. Select the desired setting. (default: "IP-PBX")
• "IP-PBX": The unit can make and receive IP
calls as a SIP extension of the PBX.
• "Peer to Peer": Peer to peer IP calls are
possible. To make a call, the other party’s IP
address is specified.
• "USB Audio": The unit operates as the USB
audio device of a computer.
4.
Press
.
5. For the new setting to take effect, disconnect the AC
adaptor from the AC outlet, then connect it again to
restart the unit.
• When you are using PoE, disconnect the LAN
cable from the unit, then connect it again.
Line Selection
Whether the TEL line, PS line, or PC line is available is
determined by the "Line Selection" setting.
1. Press [MENU].
2. Press
.
3. Select the desired setting.
• "IP + TEL": The IP and TEL lines are available.
• "IP + PS": The IP and PS lines are available.
• "IP + PC": The IP and PC lines are available.
4.
Press
.
5. Press [MENU].
Note
• When the operation mode is set to "USB
Audio", the "Line Selection" cannot be
selected.
• If you select "IP + TEL", change the dial mode
(default: "Tone") if necessary:
[MENU]®select "TEL Settings"®select
"Dial Mode"®select "Pulse" or "Tone"®
®[MENU]
IP Network, SIP Settings
To properly connect the unit to an IP network, the
following settings must be set to match the settings of
the IP network.
– IP address mode: Automatic (DHCP) or manual
(static) IP address assignment (default: static)
– IP address (when static connection mode is
selected; default: 192.168.0.2)
– Subnet mask (when static connection mode is
selected; default: 255.255.255.0)
– Default gateway (when static connection mode is
selected; default: 0.0.0.0)
To use the unit as a SIP extension of the PBX, the unit
must be registered as a SIP extension through PBX
programming, the "Operation Mode" setting must be
set to "IP-PBX" (this is the default setting), and the
following settings must be set to match the settings of
the PBX.
– SIP Ext. No.
– SIP Password
– SIP User Domain Name
– SIP Proxy Server IP Address
– SIP Proxy Server Port Number
– SIP Registrar IP Address
– SIP Registrar Port Number
Consult your system administrator for the appropriate
settings.
Note
• If these settings are changed, the unit must be
restarted before the new settings become
effective. See the Operating Instructions for
details.
• To confirm the SIP extension number, press
[MENU]®"SIP Ext. No."®
.
Document Version 2010/02 Quick Reference Guide 5
Quick Reference Guide
To Next Page
Loading...
