Making Calls
1. Confirm that the desired line is selected. Change the
selected line by pressing the center function button
[F2].
Example:
The TEL line is selected (A). The IP line will be
selected when
(B) is pressed.
2. Press [
].
3. For TEL calls: Enter the phone number.
For IP calls with IP-PBX connection: Enter the
phone number.
For IP calls with peer to peer connection: Enter
the IP address, then press [#] or [ENTER].
• IP addresses can be entered using the keypad.
[0]–[9] are used to enter numbers and [
] is
used to enter a period.
4. To end the call, press [
].
Making Calls with a PS or Computer
1. Make or answer a call using the PS or computer, and
confirm that you can talk to and hear the other party.
2. Connect the unit to the PS or computer (see
page 4).
3. Confirm that the desired setting ("PS", "PC" or
"USB-AUDIO") is selected.
• You can change the setting from "Line
Selection" (see page 5) or "Operation
Mode" (see page 5).
Example:
The PS line is selected (A). The IP line will be
selected when
(B) is pressed.
4.
Press [
].
5. End the call with the PS or computer, then press
[
].
Making Calls from the Phonebook
To add entries to the phonebook, see the Operating
Instructions.
1. Press .
2. Press [
] or [ ] repeatedly to scroll through the
phonebook entries.
3. When the desired entry is displayed, press [
] or
.
Note
• The line that was selected when the entry was
stored in the phonebook ("IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.
Example:
The TEL line will
be used when
you call this
number.
• If the "Line Selection" setting is not set to
"IP + TEL" (see page 5), TEL line numbers
cannot be called.
Making Conference Calls
1. Press
.
• The current call is put on hold.
2. Confirm that the desired line ("IP" or "TEL") is
selected.
3. Call the party you want to add to the conversation.
4. After the called party answers, press
to
begin the conference call.
Note
• When the "Operation Mode" setting is set to
"IP-PBX", only 1 IP call is possible. To have a
conference call, you must use the IP line for 1
party, and the TEL, PS, or PC line for the other
party.
Ending a Conference Call
Press [ ] to disconnect both parties.
or
1.
Press
.
2. Press [ ] or [ ] to select the party you would like
to remove from the conference, then press
.
6 Quick Reference Guide Document Version 2010/02
Quick Reference Guide
To Next Page
Loading...
