Useful Information
65
SMS (Short Message Service)
Answering system (KX-TCD240 only)
Problem Cause & solution
I cannot send or receive SMS
messages.
L You have not subscribed to the appropriate service.
Consult your service provider.
L The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers (page
40).
L Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
L SMS message memory is full. Erase unnecessary
message in the receive and send lists (page 42).
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
“FD” is displayed. L The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored (page 40). Confirm that
SMS is turned on (page 40).
“FE” is displayed. L An error occurred while sending the message. Try
again.
“E0” is displayed. L Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider.
“Q” is not displayed after you read
a message. An error code (“FD”,
“FE”, or “E0”) is displayed.
L When an error code is displayed, “Q” will not be
displayed even if you have read the message.
Problem Cause & solution
The other party complains that they
cannot leave a message.
L The recording time is set to “Greeting Only”.
Select “1 Minute” or “3 Minutes” (page 52).
L Message memory is full. Erase unnecessary
messages (page 48).
TCD230-240FX(e).book Page 65 Wednesday, June 8, 2005 7:15 PM
To Next Page
Loading...
