Panasonic KX-TCD280FX - Call Options

Base Unit Settings
32
Call options
Setting dialling mode (tone/pulse)
“ Tone ” : Select when you have a touch tone
service.
“ Pulse ” : Select when you have rotary or pulse
service.
1 Press {j /OK } .
2 Select “ Base Unit Setup ” , then press
{>} .
3 Enter “ 0000 ” (default base unit PIN).
L If you changed the PIN, enter it (page 33).
4 Select “ Call Options ” , then press {>} .
5 Select “ Dial Mode ” , then press {>} .
6 Select the desired setting, then press {>} .
7 Press {ih} .
Changing the recall time
Change the recall time, if necessary, depending
on the requirements of your service provider or
PBX.
1 Press {j /OK } .
2 Select “ Base Unit Setup ” , then press
{>} .
3 Enter “ 0000 ” (default base unit PIN).
L If you changed the PIN, enter it (page 33).
4 Select “ Call Options ” , then press {>} .
5 Select “ Recall ” , then press {>} .
6 Select the desired setting, then press {>} .
7 Press {ih} .
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your service
provider or PBX.
1 Press {j /OK } .
2 Select “ Base Unit Setup ” , then press
{>} .
3 Enter “ 0000 ” (default base unit PIN).
L If you changed the PIN, enter it (page 33).
4 Select “ Call Options ” , then press {>} .
5 Select “ Pause Length ” , then press {>} .
6 Select the desired setting, then press {>} .
7 Press {ih} .
Storing/changing emergency
numbers
These settings determine which phone numbers
can be dialled while the call bar feature is on
(page 27).
1 Press {j /OK } .
2 Select “ Base Unit Setup ” , then press
{>} .
3 Enter “ 0000 ” (default base unit PIN).
L If you changed the PIN, enter it (page 33).
4 Select “ Call Options ” , then press {>} .
5 Select “ Emergency No. ” , then press {>} .
6 Select a memory location, then press {>} .
L If the memory location already contains an
emergency number, the number is
displayed.
7 Enter/edit the number, then press {j /OK } .
L To erase an emergency number, press and
hold { C/ T } .
8 Press {ih} .
Setting call restriction
You can restrict selected handsets from dialling
certain numbers. You can assign up to 6 phone
numbers to be restricted, and select which
handsets will be restricted. Storing area codes
here will prevent the restricted handsets from
dialling any phone number in that area code. If a
restricted number is dialled, the call will not be
connected and the restricted number will flash on
the display.
1 Press {j /OK } .
2 Select “ Base Unit Setup ” , then press
{>} .
3 Enter “ 0000 ” (default base unit PIN).
L If you changed the PIN, enter it (page 33).