Panasonic KX-TCD280FX - Receiving a Message

SMS (Short Message Service)
38
5 Press {j/OK}, select “Edit
Message”, press {>}, then continue
from step 4, “Writing and sending a new
message”, page 37.
Erasing saved messages
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 Select “Send List”, then press {>}.
4 Press {e} or {v} repeatedly to select
the message, then press {j/OK}.
5 Press {j/OK}, select “Erase”, then
press {>}.
L To erase all messages, select “Erase
All”, then press {>}.
6 Select “Yes”, then press {>}.
7 Press {ih}.
Receiving a message
When an SMS message is received:
– a tone is heard (if the ringer is turned off,
this tone is not heard)
– “Receiving SMS Message” is
displayed
– F is displayed
Reading a received message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 Select “Receive List”, then press
{>}.
4 Press {e} or {v} repeatedly to select a
message.
L Messages which have already been
read are indicated by a “Q”, even if
they were read using another handset.
5 Press {j/OK} to read the message
content.
Note:
L To call the message sender, press {C}
or {s}.
L If “SMS Full” is displayed, new SMS
messages cannot be received. Erase
unnecessary messages (page 38).
L If you receive a message from a party
saved in the handset phonebook, the
stored name is displayed.
L Some SMS service providers attach a 1-
digit number to the message sender’s
phone number, and sender names stored
in the handset phonebook may not be
displayed as a result.
Replying to a message
1
While reading a received message,
press {j/OK}.
2 Select “Reply”, then press {>}.
3 Enter a message (page 40), then press
{j/OK}.
4 Edit the destination phone number
and/or press {j/OK}, then continue
from step 6, “Writing and sending a new
message”, page 37.
Editing/forwarding a message
1 While reading a received message,
press {j/OK}.
2 Select “Edit Message”, then press
{>}, then continue from step 4, “Writing
and sending a new message”, page 37.
Erasing received messages
1
While reading a received message,
press {j/OK}.
2 Select “Erase”, then press {>}.
L To erase all messages, select “Erase
All”, then press {>}.
3 Select “Yes”, then press {>}.
4 Press {ih}.