Panasonic KX-TCD530SLM

Items Adjustment
Point
Procedure
(P)
*
RSSI Level
Confirmation
- Follow steps 1 to 3 of (J) above.
4.Set DECT tester power to -81dBm.
5.Execute the command “readrssi“.
6.Confirm that the returned value is 0x09 (hex) ~ 0x19 (hex).
7.Set DECT tester power to -63dBm.
8.Execute the command “readrssi“.
9.Confirm that the returned value is 0x16 (hex) ~ 0x26 (hex).
(Q) Power RAMP
Confirmation
- Follow steps 1 to 3 of (J) above.
4.Confirm that Power RAMP is matching.
(R) Audio Check
and
confirmation
-
1. Link to BASE which is connected to Line Simulator.
2. Set line voltage to 48V and line current to 40mA.
3. Input -45dBm/1KHz to MIC and measure Line output level.
4. Confirm that the level is -10dBm ± 5dB and confirm that the distortion level is < 5% at
TEL Line (600 Road).
5. Input -20dBm/1KHz to Line I/F and measure Receiving level at REV1 and REV2.
6. Confirm that the level is -23dBm ± 5dB and confirm that the distortion level is < 5% at
Receiver (Volume Middle, 150 Road).
70