The following procedures can be used to install either 8-Station
Line Unit (KX-TD170), 4-CO Line Unit (KX-TD180/KX-
TD180D), 4-DID Line Unit (KX-TD185) or 2-ISDN S0 Line Unit
(KX-TD280). System programming is required for unit location
identification.
Default KX-TD816: bottom = 4-CO Line Unit,
top = 8-Station Line Unit
KX-TD1232: bottom = 4-CO Line Unit,
middle and top = 8-Station Line Unit
Note The KX-TD1232 is illustrated as a main unit.
2. Connect the cabinet cord to the
connector in the main unit firmly.
1. Loosen the two the screws on the cover
plate. Insert fingers into the slits to
remove the cover plate.
Note Any of the cover plates can be
removed, as needed.
3. Hook the cabinet to the main unit and
slide the cabinet to the left until it is
fixed.
Slit
Slit
4. Loosen the outside screw and slide the
cover to the right.
To Next Page
Loading...
