[Example of Entering Characters]
To enter "Ann":
A
nn
6
(5 times)
6
(5 times)
2
OR
FWD/DND
Note
• To erase the character on the cursor, press CLEAR.
• To move the cursor to the left, press .
• To move the cursor to the right, press
. When entering two or more characters that use the same
button
consecutively (e.g. "G" and "I"), you must press this button or the FWD/DND button after entering
the first character.
• If SELECT is pressed, the characters for each button will be displayed in reverse order.
• To toggle between Table 1 and Table 2 when using the KX-NT300/KX-DT300/KX-T7600 series, press
the leftmost soft button.
PT Programming Manual 15
1.1.3 Entering Characters
To Next Page
Loading...
