Panasonic KX-TG1840AL

SMS (Short Message Service)
44
L If your message contains over 160
characters, “@@Long Message@@” is
displayed. Your service provider may treat
long messages differently from other
messages. Consult your service provider
for details.
L “Invalid Number” is displayed if you
try to send a message to a phone number
saved in the handset phonebook, caller
list, or redial list that is over 20 digits long.
L When sending a message, “Sending
Message” is displayed momentarily, then
“Transferring Message” is
displayed.
L If your phone is connected to a PBX, store
the PBX line access number (page 47).
Sending a saved message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Send List”, then press {>}.
5 To read a saved message, press {e} or
{v} repeatedly to select the message,
then press {j/OK}.
L Messages are displayed in
chronological order and by destination
phone number.
6 To send the message, press {j/OK},
select “Send”, then press {>}.
7 Press and hold {C/T} to erase all
numbers, then continue from step 6,
“Writing and sending a new message”,
page 43.
Editing and sending a saved
message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Send List”, then press {>}.
5 Press {e} or {v} repeatedly to select
the message, then press {j/OK}.
6 Press {j/OK}, select “Edit
Message”, press {>}, then continue
from step 5, “Writing and sending a new
message”, page 43.
Erasing saved messages
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Send List”, then press {>}.
5 Press {e} or {v} repeatedly to select
the message, then press {j/OK}.
6 Press {j/OK}, select “Erase”, then
press {>}.
L To erase all messages in the selected
mailbox, select “Erase All”, then
press {>}.
7 Select “Yes”, then press {>}.
8 Press {ih}.
Receiving a message
When an SMS message is received:
– a tone is heard (if the handset ringer is
turned on)
– “Receiving SMS Message” is
displayed
TG1840AL(e-e).book Page 44 Tuesday, April 11, 2006 11:02 AM