– 5 –
Frequently asked questions
Question Cause & solution
Battery charge
How do I charge the battery? LMake sure that the battery is properly installed in
the handset and the cover is closed. Place the
handset on the base unit or charger. When
charging, “Charging” will be displayed.
LIt takes approx. 7 hours to charge the empty
battery. When the batteries are fully charged,
“Charge Completed” will be displayed. This
will change depending on battery charge.
Can I leave the handset on
the base unit or charger after
battery is fully charged or
each call is finished?
LYou can place the handset on the base unit or
charger anytime. Battery is not overcharged and
there is no damage to the battery. By placing the
handset on the base unit or charger, it is always
fully charged.
What should I do when the
operating time seems to be
short even after I fully
charged the batteries?
LWipe the battery ends (S, T) and the unit
contacts with a dry cloth.
Where can I buy new
battery?
LBattery can be purchased through your local
retailer.
Range/Distance (No link to base)
What is the range/distance of
my cordless phone? (Why
am I getting short or poor
range/distance on my
cordless phone?)
Why is w flashing?
LRange/distance is related to technology and
enviromental factors. Therefore we cannot
provide a given range or distance.
LMake sure that the AC adaptor is properly
connected to wall socket and to the base unit and
that beep tones sound when you press {x} on
the base unit.
LMove closer to the base unit (Allow up to 90
seconds for the handset to reassign to the base
unit.).
LIf you try manual registration process, allow up to
90 seconds for the handset to reassign to the
base unit.
LIf the above remedies do not solve the problem,
refer to the troubleshooting section in your
Operating Instructions for more information.
TG1855_1857AL(e)_QG.fm Page 5 Tuesday, June 26, 2007 6:02 PM
To Next Page
Loading...
