11
For assistance, please call: 1-800-211-PANA(7262)
Preparation
Programmable Settings
Programming Guidelines
This unit has several programmable functions which can be selected from the
function menu on the display (p. 12).
How to select a function item from the menu
• To go back to the previous menu, press Back, or press Select while
“---(Go back)----” is displayed. If you press this key in the main menu, the
unit will exit programming mode.
• After programming is complete, the display will return to the main menu or the
sub-menu depending on which menu the selected item is located. (See the menu
table on page 12.)
• You can exit programming mode at any time by pressing [OFF].
• If you do not press any buttons for 60 seconds, the handset will exit programming
mode.
• If the unit detects a problem, an error message will be displayed (p. 46) and/or
error beeps will sound.
Make sure the handset and base unit are not being used. The handset
must be operated near the base unit and while off the base unit.
1 Press [MENU].
• The main menu is displayed (p. 12).
2 Scroll to the desired item by pressing [
d
] or
[
B
].
3 Press Select to select the desired item.
4 If the item has a sub-menu, select the menu item (p. 12). Repeat
steps 2 and 3 until the desired item is displayed. If the item has no
sub-menu, go to step 5.
5 Select the desired setting by pressing [
d
] or
[
B
], then press Save to save your setting.
• A confirmation tone will be heard and the setting
will be saved.
6 Press [OFF] to exit programming mode.
Handset
Back Select
[MENU] enters the
function menu.
When “
d
” or “
B
” is displayed,
navigator key scrolls through
the menu.
[OFF] exits
programming.
The soft keys selects the
functions displayed above
each soft key.
Initial setting
Back Select
K
d
BL
Back Select
Back Save
PQQX13982YA.book Page 11 Friday, January 23, 2004 10:02 AM
To Next Page
Loading...
