“
Troubleshooting
86
Problem
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
“Recharge battery” is
displayed on the cordless
handset, “” flashes or
the unit beeps intermittently.
You charged the battery
fully, but “Recharge
battery” is still displayed
and/or “” continues to
flash.
If you cannot solve your
problem
Cause and Remedy
≥Programming is not possible while the
unit is in the talk, speakerphone or
intercom mode, when viewing the Caller
List/directory list, or while the answering
system is in use.
≥Do not pause for over 60 seconds while
programming.
≥Move closer to the base unit, if you use
the cordless handset.
≥Make sure that the unit is not being
used.
≥If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
≥Charge the battery fully (p. 11).
≥Clean the charge contacts and charge
again (p. 12).
≥Install a new battery (p. 77).
≥Call our customer call center at
1-800-211-PANA(7262).
≥Panasonic’s e-mail address for
customer inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico
ONLY
To Next Page
Loading...
