Programming
30
Programmable settings
You can customize the unit by programming the following features using the handset. To
access the features, there are 2 methods: scrolling through the display menus (page 30)
or using the direct commands (page 32).
L Mainly the direct command method is used in these operating instructions.
Programming by scrolling through the display menus
1 {MENU}
2 Press {^} or {V} to select the desired menu. i {Select}
L If there is a sub-menu(s), press {^} or {V} to select the desired item. i {Select}
Example: To access the handset ringer tone setting
Press {^} or {V} to select “Ringer setting”. i {Select}
Then press {^} or {V} to select “Ringer tone”. i {Select}
3 Press {^} or {V} to select the desired setting.
L This step may vary depending on the feature being programmed.
4 {Save} i {OFF}
Main menu Sub-menu 1 Sub-menu 2 Page
V.M. access – – page 35
Ringer setting Ringer volume ––
Ringer tone ––
Interrupt tone
*1
––
Voice enhancer –––
Copy phonebook
*1
Copy 1 item – page 25
Copy all items – page 25
Customer support – – page 33
TG262xC(e).book Page 30 Tuesday, January 24, 2006 6:03 PM
To Next Page
Loading...
