Programming
32
Programming using the direct commands
1 {MENU}
2 Enter the desired feature code.
3 Enter the desired setting code.
L This step may vary depending on the
feature being programmed.
4 {Save} i {OFF}
Note:
L In the following table:
– < > shows the default setting.
– If “System setting” column is checked,
you do not need to program the same
item using another handset (KX-
TG2622/KX-TG2624).
L If you make a mistake or enter the wrong
code, press {OFF}, then start again by
pressing {MENU}.
Feature Feature
code
Setting code System
setting
Auto talk
*1
{0}{3}{1}: On {0}: <Off>–
Change language
(Display language)
{0}{8}{1}: <English>
{2}: Français (page 18)
–
Copy phonebook (1 item)
*2
{#}{1} (page 25) –
Copy phonebook (All items)
*2
{#}{2} (page 25) –
C.WTG options
(Call Waiting options)
{0}{5}{4}{1}: On {0}: <Off>
(page 27)
r
Interrupt tone
*3
{1}{3}{1}: On {2}: <2> {0}: Off –
Key tone
*4
{0}{2}{1}: <On> {0}: Off –
LCD contrast
(Display contrast)
{0}{1}{1}–{6}: Level 1–6 <3> –
Message alert {0}{#} {1}: On {0}: <Off>–
Registration {0}{0} (page 38) –
Ringer tone (Handset)
*5
{1}{2}{1}–{3}: Tone <1>–3
{4}–{7}: Melody 1–4
–
Ringer volume (Handset) {1}{1}{1}: Low {2}: Medium
{3}: <High> {0}: Off
–
Set dial mode {0}{5}{1}{1}: Pulse {2}: <Tone>
(page 18)
r
TG262xC(e).book Page 32 Tuesday, January 24, 2006 6:03 PM
To Next Page
Loading...
