Programming
33
*1 If you subscribe to Call Display service and want to view the caller’s information after
lifting up the handset to answer a call, turn off this feature.
*2 KX-TG2622/KX-TG2624
*3 This tone lets you know when you receive a call while you are on an intercom call. If you
select “On”, the tone sounds repeatedly for as long as the line rings. If you select “2”, the
tone only sounds 2 times (KX-TG2622/KX-TG2624).
*4 You can select whether or not key tones are heard when keys are pressed. Includes
confirmation tones and error tones.
*5 If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you select a
melody, you cannot distinguish lines by their ringers.
*6 The flash time depends on your telephone exchange or host PBX. Consult your PBX
supplier if necessary.
*7 Generally, the line mode setting should not be adjusted. If “Line in use” is not
displayed when another phone connected to the same line is in use, you need to
change the line mode to “A”.
Customer support
The handset can display the Internet address where you can download the operating
instructions or get further information for this product using your computer.
{MENU} i “Customer support” i {Select} i {OFF}
Set flash time
*6
{0}{5}{2}{1}: <700ms> {2}: 600ms
{3}: 400ms {4}: 300ms
{5}: 250ms {6}: 110ms
{7}: 100ms {8}: 90ms
r
Set line mode
*7
{0}{5}{3}{1}: A {2}: <B> r
Store VM access# {0}{7}{1} Go to step 2 on page 34 r
V.M. access {3} Go to step 2 on page 35 –
VM tone detect {0}{7}{2}{1}: On {0}: <Off> r
Voice enhancer {5}{1}: On {0}: <Off>–
Feature Feature
code
Setting code System
setting
TG262xC(e).book Page 33 Tuesday, January 24, 2006 6:03 PM
To Next Page
Loading...
