Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods.
Base unit / Handset
n Scrolling through the display menus
1 MMENUN
2 Proceed with the operation for your unit.
Base unit: Press MCN, MDN, M
N, or M N to select the desired main menu. a MSELECTN
Handset: Press MCN or MDN to select the desired main menu. a MSELECTN
3 Press MCN or MDN to select the desired item from the next sub-menus. a MSELECTN
4 Press MCN or MDN to select the desired setting. a MSAVEN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MEXITN on the base unit or MOFFN on the handset.
n Using the direct command code
1 MMENUN a Enter the desired code.
Example: Press MMENUN#110.
2 Select the desired setting. a MSAVEN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MEXITN on the base unit or MOFFN on the handset.
Note:
R In the following table, < > indicates the default settings.
R In the following table,
indicates the reference page number.
R Display menu order and sub-menu may vary depending on your model.
Display the menu tree and direct command code table
n Base unit
Main menu:
“Caller List”
Operation Code
Viewing the caller list. #213 29
Main menu: “Phonebook”
Operation Code
Viewing and erasing the phonebook entry. #280 17
Main menu: “Answer device”
Sub-menu 1 Sub-menu 2 Settings Code
Screen call
– <On>
Off
#310 31
19
Programming
To Next Page
Loading...
