Answering System
For assistance, please visit http://www.panasonic.com/phonehelp 43
Listening to messages
using the handset
When new messages have been
recorded:
–“New message” is displayed.
– The message indicator on the handset
flashes slowly if the message alert
feature is turned on (page 46).
1 {MENU} i {2}
L The unit plays new messages.
L When you have no new messages,
the unit plays back all messages.
2 Press {OFF} when finished.
Note:
L To switch to the receiver, press {C}.
Voice guidance
If you do not press any buttons after the
last message is played back, the unit’s
voice guidance starts. Operate the
answering system by following the
guidance as necessary.
Adjusting the receiver/speaker volume
Press {V} or {^} repeatedly while listening
to a message.
Useful features during playback
Calling back (Caller ID subscribers
only)
If Caller ID information was received for
the call, you can call the caller back while
listening to the message.
Press {Select}, then press {Call} during
playback.
Note:
L To edit the number before calling back,
press {Select}, then press {Edit} to
select the desired format (page 34).
Answering system commands
You can also operate the answering
system by pressing dial keys of the
handset during playback.
To use the answering system commands:
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume operation, press a command
key within 15 seconds, or the voice
guidance will start.
Key Command
{1} or {<} Repeat message (during
playback)
*1
{2} or {>} Skip message (during
playback)
{4} Play new messages
{5} Play all messages
{8} Turn answering system
on
{9} Stop playback
*2
{0} Turn answering system
off
{*}{4} or
{Erase}
Erase this message
(during playback)
{*}{5} Erase all messages
TG56XX.book Page 43 Tuesday, October 4, 2005 2:10 PM
To Next Page
Loading...
