Panasonic KX-TG6572R - Page 53

53
KX-TG6572C/KX-TG6572R/KX-TGA653C/KX-TGA653R
12.2.4. Commands (Base Unit)
See the table below for frequently used commands.
12.2.5. Commands (Handset)
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address
“00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
hookoff Off-hook mode on Base Type “hookoff”.
hookon On-hook mode on Base Type “hookon”.
RdEeprom Read EEPROM Type “RdEeprom 03 e2 04”, and the data from address
“03 e2” to “03 e5” is read out
*This command gets 4 byte "WW", "XX", "YY", "ZZ".
*Please NEVER forget these 4 byte data!
sendchar epw Write EEPROM Type “sendchar epw 03 e2 04 FF FF FF FF”
sendchar RST Reset baseset Type “sendchar RST”
getchk Read checksum Type “getchk”.
sendchar epw Write EEPROM Type “sendchar epw 03 e2 04 WW XX YY ZZ”
*"WW", "XX", "YY", "ZZ" is 4 byte data that already read
from same address.
getchk Write the data of EEPROM Type “wreeprom 01 23 45”. “01 23” is address and “45”
is data to be written.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address
“00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
RdEeprom Read EEPROM Type “RdEeprom 03 7D 04”, and the data from address
“03 7D” to “03 80” is read out
*NEVER forget the read 4 byte data!
sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 FF FF FF FF”
sendchar RST Reset baseset Type “sendchar RST”
getchk Read checksum Type “getchk”.
sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 WW XX YY ZZ”
*"WW", "XX", "YY", "ZZ" is 4 byte data that already read
from same address.
weeprom Write the data of EEPROM Type “wreeprom 01 23 45”. “01 23” is address and “45”
is data to be written.