Panasonic KX-TG6671B

25
KX-TG6671B/KX-TG6672B/KX-TGA660B
8 Test Mode
8.1. Engineering Mode
8.1.1. Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
1). Press .
2). Select "Initial Setting" using or
then press or
{>} .
H/S key operation
H/S LCD
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
*
5). Enter "
٨ ", " ٨ ", " ٨ ", " ٨ " (Address). (*1)
7). Press , a long confirmation beep
will be heard.
8).
Press to return to standby mode.
After that, turn the base unit power off and then power on.
Note: * To enter "Set dial mode", press or {>} at " Set tel line".
It is necessary to turn on the power of base unit.
6). Enter " 㧖 ", " 㧖 " (New Data). (*1)
4). Select "Write EEP" using or
then press or
{>} .
{^} {V}
Default Data
New Data
INT
Caller List
^
V
^
V
Initial setting
BACK
^
V
Set tel line
BACK
BACK
BACK
CLEAR
^
V
Set dial mode
Select "Set tel line" using or
then press or
{>} .
{^} {V}
Service Mode
Read EEP
Write EEP
Set Addr.:
_ _ _ _ _ _
Set Addr.:
Set Addr.:
M
M
M
CLEAR
{OFF}
SELECT
PLAY
INT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
PLAY
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
Naviga
(Volume) key
tor key/
?
Soft keys