EasyManua.ls Logo

Panasonic KX-TG6811 Series - Unit Registration and PIN Management; Registering Units and Handsets; Changing Base Unit PIN

Panasonic KX-TG6811 Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
handsets from dialling any phone number in
t
hat area code.
1 M
N#256
2 E
nter the base unit PIN (default: 0000).
R If you forget your PIN, see page 49.
3 Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R
” is displayed next to the selected
h
andset numbers.
R To cancel a selected handset, press
the same dial key again. “
d
isappears.
4 MOKN
5 Select a memory location by pressing 1
to 6. a MOKN
6 Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
MeN
R To erase a restricted number, press
MCN.
Changing the base unit PIN
(
Personal Identification Number)
Important:
R If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, see
page 49.
1 M
N#132
2 E
nter the current 4-digit base unit PIN
(default: 0000).
3 Enter the new 4-digit base unit PIN. a
MOKN
4 MbN: Yes a MOKN a MeN
Registering a unit
Operating additional units
Additional handsets
U
p to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations may not be
available.
Registering a handset to the
b
ase unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
n
ear the base unit), re-register the handset.
1 Handset:
M
N#130
2 B
ase unit:
Proceed with the operation for your model.
n KX-TG6811 series: page 3
Press and hold M
N
for about 5
seconds. (No registration tone)
n KX-TG6821 series: page 3
Press and hold M
N
for about 5
seconds, until the registration tone
sounds.
R If all registered handsets start ringing,
press M
N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3 Handset:
MOKN a Wait until Base PIN is
displayed. a Enter the base unit PIN
(default: 0000). a MOKN
R If you forget your PIN, see page 49.
R When the handset has been registered
successfully, is displayed.
32
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Programming
TG68xxE(en)_WA_0630_ver310.pdf 32 2014/06/30 9:57:08

Related product manuals