EasyManua.ls Logo

Panasonic KX-TG6811NZ - Page 33

Panasonic KX-TG6811NZ
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R T
he handset does not beep when
cancelling its own registration.
4 MeN
Increasing the range of the base
u
nit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 5. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1 M N#138
2 MbN:
Select the desired setting. a MOKN
a MeN
Note:
R After turning the repeater mode on or off,
may be displayed on the handset
m
omentarily. This is normal and the
handset can be used once
is displayed.
Registering the DECT repeater
(
KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Proceed with the operation for your model.
n KX-TG6811 series: page 3
Press and hold M
N
for about 5
seconds. (No registration tone)
n KX-TG6821 series: page 3
Press and hold M
N
for about 5
seconds, until the registration tone
sounds.
R T
he next step must be completed
within 90 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and indicator light
g
reen.
3 Base unit:
To exit the registration mode, press M
N.
R T
he registration tone stops.
(KX-TG6821 series: page 3)
33
Programming
PNQX5803YA_0719_ver122.pdf 33 2013/07/19 10:53:44

Related product manuals