Programmable settings
You can customise the unit by programming the following features using the handset.
To access the features, there are 2 methods.
n Scrolling through the display menus
1 M
N
2 Press MCN, MDN, MEN, or MFN to select the desired main menu. a MOKN
3 Press MCN or MDN to select the desired item from the next sub-menus. a MOKN
4 Press MCN or MDN to select the desired setting. a MOKN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MeN.
n Using the direct command code
1 M
N a Enter the desired code.
Example: Press M
N#101.
2 Select the desired setting. a MOKN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MeN.
Note:
R In the following table, < > indicates the default settings.
R In the following table,
indicates the reference page number.
R Display menu order and sub-menu may vary depending on your model.
Display the menu tree and direct command code table
Main menu:
“Answer System”
Sub-menu 1 Sub-menu 2 Settings Code
Play New Msg.
– – #323 38
Play All Msg.
– – #324 38
Erase All Msg.
*1
– – #325 38
Greeting
Start REC
*1
(Record greeting)
– #302 37
Play Greeting
– #303 37
Default
*1
(Reset to pre-recorded
greeting)
– #304 37
24
Programming
To Next Page
Loading...
