Panasonic KX-TG8070E

h Base Unit Settings
18
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Base unit settings
To customise the base unit:
1 {MENU} (right soft key)
2 Select h by pressing {^}, {V}, {<}, or {>}. i {OK}
3 Enter the base unit PIN (Personal Identification Number; default: “0000”). i {OK}
4 Press {^} or {V} to select the desired item in the base unit settings menu. i {OK}
5 Press {^} or {V} to select the desired item in the sub-menu. i {OK}
6 Press {^} or {V} to select the desired setting then press {OK}.
L This step may vary depending on the feature being programmed.
L To exit the operation, press {i}.
Note:
L Use the handset to customise the base unit.
L The selected item is highlighted on the display. The currently activated setting is indicated by “t”
located on the left of the item on the display.
*1 Change the recall time, if necessary, depending on the requirements of your service
provider/telephone company or PBX.
*2 If you store the PBX access number, a pause will be added automatically between the PBX access
number and the first digit of the phone number when you make calls.
*3 If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you.
*4 If you forget your PIN, consult your nearest Panasonic service centre.
Menu Sub-menu Details (default setting)
Ringer Setup Ringer Volume For base unit (“Volume 3”)
Ringtone (“Ringtone 1”)
Call Options Dial Mode (“Tone”): page 12
Recall/Flash Recall time (“100 msec.”)
*1
PBX Access No. Enter the 1-digit code. i {OK}
*2
Base Unit PIN — Change base unit PIN (“0000”).
*3
– Enter the new 4-digit base unit PIN.
*4
i
{OK}
– Enter the new 4-digit base unit PIN again.
i {OK}
TG8070-8090E(e).book Page 18 Monday, June 11, 2007 8:12 PM