Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods.
Base unit / Handset
n Scrolling through the display menus
1 MMENUN
2 Proceed with the operation for your unit.
Base unit: Press MDN, MCN, M N, or M N to select the desired main menu. a MSELECTN
Handset: Press MDN, MCN, MFN, or MEN to select the desired main menu. a MSELECTN
3 Press MCN or MDN to select the desired item from the next sub-menus. a MSELECTN
4 Press MCN or MDN to select the desired setting. a MSAVEN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MnN (EXIT) on the base unit or MOFFN on the handset.
n Using the direct command code
1 MMENUN a Enter the desired code.
Example: Press MMENUN#110.
2 Select the desired setting. a MSAVEN
R This step may vary depending on the feature being programmed.
R To exit the operation, press MnN (EXIT) on the base unit or MOFFN on the handset.
Note:
R The unit column shows the unit(s) that can be used to program the item.
: Only the base unit can program the item.
: Only the handset can program the item.
/ : Both the base unit and handset can program the item.
R In the following table, < > indicates the default settings.
R In the following table, indicates the reference page number.
Display the menu tree and direct command code table
Main menu: “View Caller ID”
Operation Code Unit
Viewing the caller list. #213
/
33
Main menu: “Phonebook”
Operation Code Unit
Viewing and erasing the phonebook entry. #280
/
25
(Base unit) Main menu: “Set answering”
Sub-menu 1 Sub-menu 2 Settings Code Unit
Record greeting Line1&Line2
– #302 36
Line1
–
Line2
–
27
Programming
To Next Page
Loading...
