Making cellular calls
Important:
R Only 1 cellular line can be used at a time.
R Before making calls, confirm that the
corresponding CELL indicator on the base unit
lights up (page 15).
1 Lift the handset and dial the phone number.
R To correct a digit, press MCLEARN.
2 MCELLN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make cellular calls
(page 20).
Go to step 4.
3 MbN: Select the desired cellular phone. a
MSELECTN
4 When you finish talking, press MOFFN or place
the handset on the base unit or charger.
Note:
R To switch to the speaker, press MZN.
To switch back to the receiver, press MZN/M
N.
Adjusting the receiver or speaker volume
Press MDN or MCN repeatedly while talking.
Making a cellular call using the redial list
The last 5 phone numbers dialed are stored in the
redial list (each 48 digits max.).
1 MEN REDIAL
2 MbN: Select the desired phone number.
3 MCELLN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make cellular calls
(page 20).
4 MbN: Select the desired cellular phone. a
MSELECTN
Erasing a number in the redial list
1 MEN REDIAL
2 MbN: Select the desired phone number. a
MERASEN
3 MbN: “Yes” a MSELECTN
4 MOFFN
Making landline calls
1 Lift the handset and dial the phone number.
R To correct a digit, press MCLEARN.
2 M
N
R An available line is automatically selected.
To change the line selection mode, see
page 16.
R You can also select the line manually by
pressing ML1N or ML2N.
3 When you finish talking, press MOFFN or place
the handset on the base unit or charger.
Note:
R The LINE 1 indicator or LINE 2 indicator on the
base unit lights up while using the handset.
Using the speakerphone
1 Dial the phone number and press MZN.
2 When you finish talking, press MOFFN.
Note:
R To switch back to the receiver, press MZN/M
N.
Making a call using the redial list
The last 5 phone numbers dialed are stored in the
redial list (each 48 digits max.).
1 MEN REDIAL
2 MbN: Select the desired phone number.
3 M
N
Pause (for PBX/long distance service users)
A pause is sometimes required when making calls
using a PBX or long distance service. When
storing a calling card access number and/or PIN in
the phonebook, a pause is also needed
(page 34).
Example: If you need to dial the line access
number “9” when making outside calls with a PBX:
1 9 a MDN (Pause)
2 Dial the phone number. a M
N
Note:
R A 3.5 second pause is inserted each time MDN
(Pause) is pressed.
22
For assistance, please visit http://www.panasonic.com/help
Making/Answering Calls Using the Handset
To Next Page
Loading...
