25
Programming
De-register a handset
Available for: KX-TGB112
Use one handset to de-register
another. The handset being used
cannot de-register itself.
1
LmR
,
L
d
R
“ADVANCED
SET”, press
LmR
.
2
L
d
R
“UNREGISTER”, press
LmR
.
3 Enter the 4 digit PIN code (default
= 0000), press
LmR
.
4
L
d
R
to select the handset that
needs to be de-registered. A
conrmation beep will be heard
and the display will return to the
previous menu.
Restore default settings
The phone can be restored to its
default (original) settings. All the
handsets that are registered to the
base will be retained.
IMPORTANT
Resetting the phone to its default
settings will delete all entries in the
Calls list. Current handset and base
settings will also be reset. Entries
stored in the phonebook are retained.
1
LmR
,
L
d
R
“ADVANCED
SET”, press
LmR
.
2
L
d
R
“RESET”, press
LmR
.
3 The display shows “RESET ?”.
4
LmR
to conrm or
LpR
to return
to the previous menu. The phone
will restart automatically.
Registering a handset
Note:
Handset batteries must be fully
charged before registration. Hold the
handset close to the base during the
registration process.
Handsets that were supplied with the
base are already pre-registered.
On the base:
1 Press and hold
L
p
R
for 5
seconds. The base will remain in
registration mode for 90 seconds.
On the handset:
2 If the handset is not register to a
base, press
LmR
and then enter
the 4 digit PIN code (default =
0000), press
LmR
.
3 If the handset is already register
to a base, press
LmR
,
L
d
R
“ADVANCED SET”, press
LmR
.
4
L
d
R
“REGISTER”, press
LmR
.
5 Enter the 4 digit PIN code (default
= 0000), press
LmR
.
A beep will be heard if the registration
is successful. The handset is
automatically assigned an available
handset number. Use this number
when making internal calls.
Note:
If registration is not successful the
rst time, please repeat the process
again in case the base registration
period ran out of time. If the base
is not found after a few seconds,
the handset returns to standby. Try
registering again.