20
USER GUIDE
Panasonic DECT KX-TGP600 User Guide
Storing an Item Using the Dialing
You can dial a number rst and then add it as a phonebook entry.
[In standby mode]
1. Dial a number.
2.
3. Enter a name (max. 24 characters). →
4. [▲]/[▼]: Select a phone number type (1 to 5). →
5. Edit the phone number if desired. →
6. Repeat steps 4 and 5 to add additional phone number types.
7. [▲]/[▼]: “Category O” →
8. Select a category. →
9. To select a default number for the entry, press [▲] or [▼] to select “Default TEL No” →
10. [▲]/[▼]:: Select the number to use as the default number. →
11.
Note:
• Steps 7 and 8 can be omitted if you do not want to assign a category.
• Steps 9 and 10 can be omitted if you do not want to assign a default number. (The rst number entered for an entry will automatically be
assigned as the default number.)
• The valid digits are “0” through “9”, “g”, “#”, “+”, “P”.
• If an item with the same name and number exists, the new information added will be merged with the existing item.
Storing an Item Using the Incoming or Outgoing Call Log
You can add a number listed in the Incoming or Outgoing Call Log to the Handset Phonebook.
[In standby mode]
1. Display the incoming or outgoing call log. For details, see “Appendix A” on page 25.
2. [▲]/[▼]: Select the desired item. →
3. [▲]/[▼]: “Save Phonebook” →
4. Edit the name if desired. →
5. [▲]/[▼]: Select a phone number type (1 to 5). →
6. Edit the phone number if desired. →
7. Repeat steps 5 and 6 to add additional phone number types.
8. [▲]/[▼]: “Category O” →
9. Select a category. →
10. To select a default number for the entry, press [▲] or [▼] to select “Default TEL No” →
11. [▲]/[▼]: Select the number to use as the default number. →
To Next Page
Loading...
